Ordered 31.05, came 8.06, just in case unpacking shot on the video, because. In some places, the box was sold, but the fears turned out to be futile! Inside I was waiting for quality packaging of foamed soft material. Immediately say in the kit was all! Even a spatula + needle for cleaning the nozzle and another additional nozzle of the extruder. The Assembly took about 3 hours, I will immediately say, the jambs are... For example, I advise vertical guides immediately do not tighten! Stretch only after installing the top spacer, the stud on the z axis is perfectly flat, but when tightened in the coupling and the subsequent installation of the crossbar on which it was moved I was afraid that I would eat, but the first test showed that my fears were not justified, apparently due to not a metric thread... I bet with the table fit! In the end, I advise firstly how to use a cardboard paper, which meets you immediately after opening, second to adjust the criss-cross! good luck I'll add after 24 hours. Printer work. Important! From the box strongly heated engine! Set voltage values on drivers 0.9 V!!! On the Z axis is still heated strongly, 1 photo while put this for blowing (copes). 2 Photos: Surrounded by 1 and 2 loosen! 1 slightly, 2 - 3 turns. 3 Photos: The Roller is already beginning to wear out decently provided that it does not stretch very much..., but it's because of the principle of design. The control board is also very heated! A small cooler does not cope with the task, you need either more or more on blowing. The surface of the glass is excellent, immediately bought glue for printing, together it works Superski. The printer is satisfied, +-for its money it is not bad, but there is something to put your hands on... Good luck friends!